Whole Home Water Filtration System Orlando
407-830-1155
Get a Quote
BRITA PRO®

Whole House
Aeration Filter

Reduces Hydrogen Sulfide Gas, Iron, Manganese
Brittany pro

Reduces Hydrogen Sulfide Gas, Iron, Manganese

  • Reduces hydrogen sulfide gas, iron and manganese without the use of chemicals
  • Filters all household water at the point of entry
  • Treats water to protect pipes, faucets, water heaters, boilers and all appliances requiring the use of water
  • Flow rates that won’t disrupt household water pressure
  • Simple and easy to run with high-efficiency operation
  • Simplified single-tank installation
  • State-of-the-art control valve
  • For hydrogen sulfide, higher levels of iron, manganese and sediment
  • This unique light weight, high surface area filtration media utilizes a high concentration MnO2 catalytic coating technique. It provides higher filtration rates, longer service life and reliable performance without producing a disinfection by-product
  • Made in an IAPMO-certified manufacturing plant
control-value
pressure-tank
usa-logo

COMPONENTS & SPECIFICATIONS

WHOLE HOUSE AERATION FILTER SPECIFICATIONS
Model No Mineral (Cu. Ft. ) Service Flow GPM 1, 2, 3 Backwash GPM 4, 5 Mineral (Dia. x Ht. ) Influent Limitations
BP1KATAIR1J Katalox Light (1.0 ) 2.7 to 4.6 5.3 10” x 54”
  • Hydrogen Sulfide up to 5 ppm
  • Iron up to 6 ppm
  • Manganese upto1 ppm
  • High concentration of contaminant may require upstream dosing of H2O2, KMnO4 or chlorine to accelerate catalytic oxidation
  • DO NOT install on water supplies containing organic matter (Tannins)
  • ffective with pH as low as 5.8. removing Iron - recommend pH 7.5 or higher but below 8.5, Manganese - recommend pH 8.5 but below 8.5 if Iron is present
Engineered to utilize aeration, oxidation, and mechanical filtration to remove hydrogen sulfide, higher levels of iron, mangenese, and sediment without the use of salt and chemicals.
  • Katalox Light service flow rates based on Continuous (5 GPM/sq.ft.) to Intermittent (Peak) (10 GPM/sq.ft.).
  • Lower service flow rates arerecommended for increased contact time to produce higher quality water. Higher flow rates are possible, however, filtration quality may be compromised.
  • Backwash flow rates based on DLFC sizes to meet approximately 10GPM/sq.ft.
  • Well pump capacity must be equal to or greater than the required backwash flow rate to assure proper backwash. Ifthe well pump cannot provide the required backwash flow rate, consider two smaller filters, parallel installation with offset backwash times.

SYSTEM DIMENSIONS

Models A (Inches) B (Inches) C (Inches)
BP1KATAIR1J 54 10 16.5
Call Now!