fbpx
blown in Insulation near Orlando

5 Things You Must Know About Blown In Attic Insulation

When the weather gets cooler outside, or the hot sun is beating down on your home, you may be finding yourself looking up and wondering if the attic requires better protection from this winter weather. It’s been a long time since the upstairs area under your roof was upgraded. You may be ready to make some improvements, but you want to make sure that you’re choosing the best attic insulation. Read on to learn more about blown in insulation and whether or not it is the right choice for your home. When our teams at Home Makeover Systems deal with attic insulation, it’s typically through our residential restoration services. Home Makeover Systems is a top provider of attic insulation Orlando residents trust. Call Home Makeover Systems at our Longwood office for your insulation needs today!

 

What To Know About Blown In Attic Insulation

 

Here are some must-know facts about this type of insulation:

 

  • Blown in insulation fills between existing wall studs and ceiling joists extremely quickly and easily- During new construction, batt insulation (thick strips of spun fiberglass or a paper-based product) is cut to fit between wall studs and ceiling joists before wallboard is put up in order to increase insulation values. Putting in batts in most existing homes, however, is not very feasible, since drywall would need to be taken down, a messy, expensive, and time-consuming operation. Blown in insulation can be added to attics and walls without all of this hassle. Moreover, this type of insulation is also able to seal small gaps and spaces as it settles to fill the sneaky spots where cold or hot air would otherwise sneak in. This type of insulation also helps to reduce the sound transfer to soften unwanted noise, in addition to creating an insulating blanket.
  • There are certain disadvantages- In order to install this type of insulation, holes have to be drilled at the top of each stud space (typically on the exterior), and material is blown in through a long, flexible hose. The hole is then sealed with a plug. Even if the plugs are closely matched to the color of the siding, they are still often noticeable. Another disadvantage to this kind of insulation is that any obstruction on the wall like a drainpipe can keep the insulation from filling the entire stud.

 

Facts About Blown In Insulation

  • There are three kinds of blown in insulation- The three main categories are loose-fill fiberglass, cellulose, and rock wool. Home Makeover Systems, a top provider of attic insulation Orlando residents trust, note that each type of insulation has its own pros and cons, which is why it’s so important for homeowners to do their research prior to installation. 
  • Blown-in insulation can be bought from different sources- Bags of both cellulose and loose-fill fiberglass insulation can be purchased from most home improvement stores if you’re thinking of installing it yourself, but you will need a blower.
  • You can install it yourself, but it can be tricky- Blowing insulation into walls is best left to the pros due to the fact that you will need to drill into stud spaces that may contain electrical wiring and pipes. However, it CAN be a DIY task, even though it is not recommended.

 

Contact Us Today

 

Blown in insulation may be the right choice for you. Call Home Makeover Systems at our Longwood office for attic insulation Orlando residents trust today!

 

Leave a Comment

Your email address will not be published. Required fields are marked *

Call Now ButtonCall Now!